ezgif-2-20d8857cea00.png

TECHNICAL SPECIFICATIONS

Detailed specs for Anthem One (Mark Two), Anthem Power (Mark Two), Anthem Light Cards and
Anthem Thermal Paste

ANTHEM ONE (MARK TWO)

The best light in the world just became better. Anthem One's heat sink, electrical contacts, polycarbonate faceplate, rear socket and stainless steel bottom-socket have all been upgraded and enhanced. And as always, Anthem One is military-grade tech. We've dropped Anthem One onto concrete from four feet 100 times and it still works.

anthem-one-specification___img2_beee2b68-fb92-45bf-9ccc-a0d75e68b9cd.jpg
anthem-one-specification___3_a0a78e60-0a24-40ac-8b22-08a9e0bb4c93.jpg

ANTHEM LIGHT CARDS

At 12mm (.04 inches) thin, 60mm (2.3 inches) square and weighing less then 28 grams (1 ounce), Anthem Light card is unlike any light source on earth. Anthem Light Card lasts up to 50,000 hours, making it the longest lasting light source ever created. Anthem Light Cards can be swapped out of Anthem One in less then 1 minute. As LEDs grow brighter, users can replace their existing Light Cards to increase Anthem One's brightness rather then replace their entire lighting system. At long last, your source of light has more in common with RAM or hard drives than with 19th century glass tubes.

anthem-one-specification___4.jpg
Anthem_Light_Card_Agriculture_Full_Spectrum
Anthem_Light_Card_Amber_600
Anthem_Light_Card_Black_Light_365
Anthem_Light_Card_Daylight (1)
Anthem_Light_Card_Green_Screen
Anthem_Light_Card_Military_Grade_IR
anthem
Anthem_Light_Card_Red_650
Anthem_Light_Card_Interior (1)
Anthem_Light_Card_Ultra_Bright
IMG_4636
Anthem_Light_Card_Ultra_Color
Anthem_Light_Card_Yellow_590

BEAM SPECIFICATIONS

 Anthem Light Card's beam is 160 degree at the source. This defies conventional wisdom; it is a massive wall of smooth, pure, punchy light without any modification. The light field behaves more like the sun than any other artificial light source.However, it is effortless to modify. Simply attach one of our magnetic speed mounts with an off-the-shelf grid, fresnel lens, reflector dish or snoot to change the beam diameter. Changing from 160 degrees to 20 degrees only takes 2 seconds.The beam has no hot spot and is perfectly even from edge-to-edge. We've lit a 20 story building, from sidewalk to rooftop, standing on a 14th story balcony 100 feet away. You can comfortably illuminate a half-acre or a 5-story building with a traditional light stand. 

anthem-one-specification__img5.jpg
anthem-one-specification-page_07.png
Specification_img_03.png

Because our visible light cards are made of 900 individual light sources, the beam has off-axis punch and is best visualized as a cone with its tip cut off.

Anthem Light Card's light field is effortless to modify. Simply attach one of our magnetic speed mounts with an off-the-shelf grid, fresnel lens, reflector dish or snoot to change the beam diameter. Changing from 160 degrees to 20 degrees only takes 2 seconds.

BATTERY LIFE

Say goodbye to gasoline generators, cable runs, fumes, noise and the large trucks necessary to tow them. Lithium-ion is here...and Anthem One is the most electrically efficient high-output light on earth.

With batteries, every lumen-per-watt counts.

battery_life.jpg
Anthem_Thermal_Paste.png

ANTHEM THERMAL PASTE

Anthem Thermal Paste is odorless, non-volatile, non-corrosive, non-toxic, flame retardant and not electrically conductive. Each syringe of thermal paste contains approximately two grams (approximately five applications).

Applying Anthem Thermal Paste is simple. Remove the front four screws surrounding Anthem Light Card. If thermal paste is moist, then no re-application of thermal paste is necessary. If the thermal paste is dry and flakey, wipe clean with a wet wipe and apply two rice-grains in the center of the heat sink.

WATCH VIDEO

Anthem One Mark I and Mark II invented by Justin Eugene Evans